Help with tranny swap wiring plz....
I have a 95 e34 525i that I am in the process of swapping the tranny for a 98 M3 ZF320 5-speed & 99 M3 3.2L back to ODB-1. I have the auto out and I am now working on the WIRING. I have tried to solve this on my own but and not still 100% sure what is what. I have tried to sort it out via the Bentley wire diagrams. Can you please ID the numbers in the picture please. Which 2 wires are connected to the tranny for backup. Also any other info. you can provide. I believe that the starter relay gets jumped to neg. via 30-87. How do you suggest to take care of the CCM? Where is the best place to do this? These pic's were taken before the tranny was pulled.
#1. is this the auto gear select switch? If so which 2 wires to the tranny?
#2. this one was not connect to anything??
#3.Brake Light Switch?
#4.
#5.
http://www.bigfootdesigns.com/bmw/slushbox.gif
Much thanks and any help is better than none!
Brian
You may want to check this thread ...
Did you look after Green/Black and Blue/Yellow wires ...
at connecting plug #1 of your picture?
Green/Black have 12 Vdc from Fuse F12 and Blue/Yellow will light on reverse lamps when connected to Green/Black. Reverse switch at the driver's (left) side of the trany should have two wires, may be some one pulled out the missing wire?
Guess you did already run a wire from Green/Red of same connecting plug #1, to pin 5 of Starter Immobilization Relay.
For the interlock cable, guess you will figure out.
Javier