PDA

View Full Version : Throttle Body



clindahl
12-16-2007, 05:14 PM
Has anyone ever had any problems with nipples on the throttle body coming off? Attached is a picture of a throttle body I saw on e-bay.

I am trying to narrow down a vaccum leak, and when removing the hose on the nipple of the idle air motor, the nipple came right out of the throttle body housing, it appears as though it was held in with JB Weld?


Any input or thoughts on how to repair this, or buy a used throttle body?

AngryPopTart
12-19-2007, 09:05 PM
I've been wondering about this, too. I've always been able to just kinda jiggle them out or even simply slide them out, very easily. I JB'd one of them... I think the one the ICV is on. I think it's time to JB the other two, especially since even after the engine swap, I have the troublesome idle, and the dead spot when first giving it throttle. Maybe these are to blame. I think we replaced every vacuum hose, but these little metal dudes that slide into the throttle-body I am still worried about.

Also, my Paps was humoring the possibility of the butterfly rod wearing out where it contacts the housing, possibly allowing air to pass. It stands to reason that this is a possibility, but would like more input.

Gearhead
12-20-2007, 04:16 AM
I've seen that butterfly rod wear out and cause vacuum leaks many times on carburetors, but have yet to see it on a throttle body. The quickest way to tell is to get a can of starter fluid and start spraying around these areas when the car is running. If the idle jumps, you found your vacuum leak.

ahlem
12-20-2007, 03:42 PM
More JB Weld. This happens on other models as well.

clindahl
12-21-2007, 12:10 PM
interisting, but good to know. I see what I will be doing this weekend :)

clindahl
12-21-2007, 03:12 PM
Throttle Body w/ Loose Nipples Removed (http://www.thelindahls.com/users/carl/bmw/bmw4.jpg)


Cleaning out the holes (http://www.thelindahls.com/users/carl/bmw/bmw5.jpg)

Other Hole Clean - that one nipple wouldn't budge (http://www.thelindahls.com/users/carl/bmw/bmw6.jpg)

Lots of JB Weld - it looks like what was on there (http://www.thelindahls.com/users/carl/bmw/bmw7.jpg)

Somewheat related note, changing out some of the hoses that connect to the right two nipples and the brake booster. (http://www.thelindahls.com/users/carl/bmw/bmw8.jpg)

Jeff325525
12-22-2007, 12:58 PM
Has anyone ever had any problems with nipples on the throttle body coming off? Attached is a picture of a throttle body I saw on e-bay.

I am trying to narrow down a vaccum leak, and when removing the hose on the nipple of the idle air motor, the nipple came right out of the throttle body housing, it appears as though it was held in with JB Weld?


Any input or thoughts on how to repair this, or buy a used throttle body?
I just put blue silicone on it when I put it back together. Then it is easy to get apart the next time.

Jeff