730i/replacing rear axle carrier rubber mounting/easy?

[nsbone_1988_520i]

Hi,

both of my rear rubber mounting (part #2 in diagram below) for rear axle carrier are busted. I need to replace them.

Appreciate for comment on replacing them:
- is it DIY? (I can change absorber on my own.. so i'm a bit DIYer)...
- other than the rubber mounting, what else critical to replace at the same time?
- Can i do this alone?
- how to push out the old rubber?
- and how to push in the new rubber mounting?

thanks in advance,
rahman

http://www.realoem.com/bmw/diagrams/o/k/9.png

[shogun]

I assume you mean the beer cans. There is a lot in archives here in the 5 series forum, or here
http://www.bimmerboard.com/forums/e32/search/?q=beer+can&forum=e32

[nsbone_1988_520i]

I assume you mean the beer cans. There is a lot in archives here in the 5 series forum, or here
http://www.bimmerboard.com/forums/e32/search/?q=beer+can&forum=e32

Hi Shogun,
Thanks for the link. Yup, it's the beercan. But after looking at some of the postings, i think will change the pitman arm bushes as well...


regards,