+ Reply to Thread
Results 1 to 4 of 4

Thread: a/c fan control will not operate the blower

  1. #1
    Join Date
    Jan 2004
    Location
    Pembroke Pines, FL
    Posts
    97

    Default a/c fan control will not operate the blower

    The switch works on heat only on high; however, it does not blow any when air conditioner controls are on...any ideas?
    I live in South Florida & need the a/c to blow cold...don't really care about the heater blowing only on high.
    Thanks in advance for any assistance, Bill H.
    Bill Harrison

  2. #2
    Join Date
    Jan 2004
    Location
    Pembroke Pines, FL
    Posts
    97

    Default so now no fans at all-heat or a/c

    any suggestions out there?
    Bill Harrison

  3. #3
    Join Date
    Jan 2004
    Location
    Pembroke Pines, FL
    Posts
    97

    Default fixed a/c, thank you very much.

    While tracing/looking for a relay between the glove box & radio under the dash...found white 6 pin female connector not p=connected to the male connector...plugged them together and a/c fan blows cold through dash just like it is suppose to!
    Bill Harrison

  4. #4
    Join Date
    Jan 2004
    Location
    Pembroke Pines, FL
    Posts
    97

    Default found problem

    The small board on each side, heat & air, have common problem frying components...practicing soldering now before get on the boards.
    Bill Harrison

+ Reply to Thread

Similar Threads

  1. Heater blower, blower resistor, service manual, custom socket for strut
    By Garlic Breath in forum Swap Meet - Classified Ads
    Replies: 1
    Last Post: 11-11-2009, 12:41 PM
  2. Should windows operate w/key off and out?
    By billy in slo in forum 5 Series BMW
    Replies: 7
    Last Post: 03-08-2005, 09:11 AM
  3. e34 climate control blower problem
    By sanga in forum 5 Series BMW
    Replies: 1
    Last Post: 09-02-2004, 09:06 AM
  4. Auto Climate Control: Blower only runs at full speed
    By Black530i in forum 5 Series BMW
    Replies: 5
    Last Post: 07-25-2004, 08:44 AM
  5. Replies: 3
    Last Post: 06-30-2004, 05:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts